Texas Hunter 250 lb. Lake & Pond Directional Fish Feeder with Adjustable Legs

The DF425AL: Texas Hunter 250 lb. Lake & Pond Fish Feeder with Adjustable Legs.

Hopper Dimensions: width 28 in x length 28 in. x height 50 in.

The Texas Hunter Products DF425 Directional Feeder rests at ground level and delivers feed over a wide wedge- 45 feet in length by 20 feet in width.The feed is propelled forward and away from the feeder. This prevents attracting wildlife and varmints directly to the feeder. This unit is equipped with two motors. This allows the first lower motor to reach full speed before any feed is released. The second upper motor then cuts on releasing feed for the desired amount of time. The top motor then turns off and a few seconds later the bottom motor turns off.The result is no feed is wasted.All feed is propelled out into your lake or pond. No feed drops at the base of the feeder. This design eliminates the need for special shut off gates at the base of the feeder.These shut off gates have caused problems in other directional feeders.

This unit is available with two different type leg sets:

• Order the DF425DL with straight/dock legs if you intend to place the feeder on a dock.
• Order this feeder the DF425AL with angled/bank legs if the feeder will be sitting on the bank of a lake or pond.

Click Here: To Check Current Processing and Shipping Time for this item.

Key Features:

• 250 lb. capacity for fish feed
• Heavy 20 gauge galvanized steel construction
• Powder coated hunter green finish
• Low profile 11 gauge powder-coated steel leg set
• Two motor design
• Powerful 12-volt motors and centrifugal air blower assembly
• Feed is delivered in a wedge-shaped pattern: 45 feet in length by 20 feet in width
• Controlled by DFT12 premium digital timer
• Quick-Rrelease access panel with clear-view funnel
• Less than 5 feet high for easy filling
• Powered by a 12-volt rechargeable battery
• Lockable lid
• Lockable timer and battery door
• Two Sight gauges for easy feed level reference from either side of the feeder
• Nutserts allow you to install legs from the outside of the feeder
• Adjustable height angled/bank legs
• Footpads included allowing you to easily bolt this unit to a pier or dock
• Ships with four heavy duty stakes to secure your feeder on the bank
• Solar charger can be easily installed on any side of the feeder (not included)
• Order the SP2W 2 watt solar charger at the bottom of this page.
• The SP2W is highly recommended so you will not have to pull and recharge the battery.

• Feeder: 1 Year Warranty

• DFT12 Timer: 5 Year Limited Warranty